Atlantic Auto Suppliers - Mohawk Lifts

• A variety of track lengths from 26’ to 48’ long.
• 35,000 through 100,000 lb. capacities.
• Surface mounted, recessed or flush mounted.
• Rolling air-hydraulic jacks in capacities of 25,000 lb.or 50,000 lb. capacities for wheels free service.
• Full undervehicle access for all buses, trucks & heavy equipment.
• Full 63” lifting height on either surface or flush mounted model.
• Full and clear, unobstructed under-the-vehicle access without structural cross brace, or torsion bar.
• 12 position mechanical safety locks in all legs starting at 24”.
• All lifts are plumbed for air lines in the runways, prewired for florescent runway lighting with no separate 110V power supply required for added options.

Design Benefits

• The heaviest built parallelogram in the world for your heavy duty lifting requirements.
• Large 7 ¾" cylinders equal more power, lower PSI and longer component life.
• Self lubricating composite bearings with chrome plate pivot pins for mainteance free operation.
• Sturdy base design minimizes stress on the shop floor, allowing installation virtually   anywhere.
• No structural cross brace (torsion bar) between the platforms eliminates a trip hazard and   the antiquated technology of a mechanical brace between the platforms.
• Hydraulic safeties throughout consisting of pressure compensated flow control valves   and velocity fuses.

Control System

• Computer controlled platform synchronization is programmable for different lifting height   to accommodate various vehicles, low ceilings or different height technicians.
• Computer controlled dual high resolution, chain driven encoders monitor synchronous   lifting and lowering 60 times per second.
• The computers alpha-numeric LCD display performs self test on start-up, with   information in plain english, with no flashing lights to
  be decoded.
• Control system user settings are input directly from the keypad or special settings are   password protected. No outside computer is needed for reprogramming various   settings.
• All platform switches and electrical sensors are located in the runway and not the shop   floor. Continuous electrical runs from lifts console eliminates splice connections at the   shop floor.
• 24 volt control circuit provides operator safety during control
console operation.
• Manual pump and valving allow lowering in a no power situation.

Surface Mounted or Flush Mounted with Runway Lengths from 26’ to 44’ long


Mohawks clear work area has no obstructive tie bar between the runways for total access.	Simple 3 button operation; Raise, Lower & Park (lock). 24 volt controls for operator safety, lockout standard, with easily programmable computer controls.	U.S. made G.E. internal computer & U.S. control components, simple wiring, 24 volt DC power, step-down transformer, fuses and starter box make the Mohawk parallelogram easy to operate, with nothing to maintain & readily accessible guaranteed parts availability.	Mohawk base design assures stability is spread throughout the lift, and gives more strength than lifts which place all the load in one concentrated floor spot. Mohawk lifts only need minimal 6" thick concrete requirement


Counterbalanced manual or air- hydraulic tire dolly makes removing heavy truck tires a simple & safe one man job.	Mohawk safety latch racks are made of laser cut high strength T-1 steel, and assure safe smooth locking at all working heights.	Optional rolling air-hydraulic jacks operate individually and make "wheels free" service simple. Optional florescent runway lighting illuminates the vehicle undercarriage.	Optional florescent track lighting


For ultimate shop space savings, the flush mounted parallelogram is installed recessed in a pit, making the lift "invisible" when not in use to maintain maximum shop work flow.